Development build — sample configuration

Map network zones and how the network is connected

Split the network into metered zones with an inflow meter, connect nodes and pipe sections from the intake to the service taps, and check on the Network map what already has coordinates.

Updated on

Metered zones and the topology record where water enters the network and which way it flows. The water balance and the isolation calculation both depend on them. The Owner, Administrator and Operations roles create zones, nodes and links; Field supervisor, Field reader, Analyst and Viewer can open these pages read-only.

Before you start#

  • Every zone belongs to a service area. Create areas under Settings → Service areas.
  • Each zone's inflow and outflow meters must already be in the meter list so you can pick them.
  • For an asset to show on the map, have its latitude and longitude ready.

Step 1: Create the metered zones#

  1. In the menu, under Network, open Metered zones.
  2. Click New area.
  3. Fill in Name and Code and choose the Service area.
  4. Under Inflow meter, pick the meter that measures water entering the zone. If the zone exports water to another one, also set the Outflow meter.
  5. If you have a reference value, fill in Target pressure (bar), then click Save.
  1. Under Network, open Topology and click New node.
  2. Under Type, choose for example River intake, Borehole, Reservoir, Zone inlet or Customer service line.
  3. Fill in Code and Name. A Zone inlet needs a Metering zone; a Customer service line takes a Customer meter. Save.
  4. Once two nodes exist, click New link. Set the Code, the From and To nodes, the Type and the Status (Open, Throttled or Closed). Length (m) and Diameter (mm) are optional.
  5. Open the Pipe sections page to review every link.

Step 3: Check the Network map#

  1. Under Network, open Network assets and use New asset to add reservoirs, valves or pipes with a Latitude and Longitude.
  2. Open Network map and switch layers on or off: Network assets, Metered zones, Properties, Meters, Open incidents, Work orders and Active alarms.

What happens next#

The zone joins the list with the message Metered area registered, and you can now choose it on the Water balance screen and in the interruption form. In the topology, opening a node lets you follow the flow with Upstream or Downstream; opening a link and clicking Isolate works out the Valves to close, the Affected service taps and the Affected customers. On the map, a separate section counts and lists the records that have no location yet, each with Open record so you can complete it.

Common problems#

  • Saving a link shows "This link would close a loop." Water flows one way, from the intakes to the service taps. Swap the From or To node.
  • You see "A link with this code already exists." Link codes are unique; pick another.
  • You see "A zone inlet needs a metering zone." Create the zone in Step 1 first, then choose it on the node.
  • The Isolate result shows Valves alone cannot isolate it. Some path from the intake to that pipe has no shut-off valve. Add the missing Control valve link to the topology.

Start today. Set up your utility in minutes.