Development build — sample configuration

Work without signal in the field app

Keep recording readings, visits and field orders with no signal, check what is waiting on the To send tab, and send it once you are back online.

The field app is built for places with no signal. What you record is saved on the phone first and waits on the To send tab until it can reach the service. This page is for readers, crews and supervisors who use the app in the field.

Before you start#

  • Open the app while online before you leave. It downloads your route, each meter's history and your van stock, and shows them later as last read.
  • Stay signed in to the same account and organisation until your records are sent. Records only go out under the account and organisation they were saved in.

Step 1: Work as usual#

  1. Record readings, visits, incidents, completed orders, disconnections, meter changes and stock steps the normal way.
  2. After each save, the app confirms that the record is kept on the phone, for example "Visit saved. It will be sent when you are online."
  3. Photos are kept on the phone with their record and are sent first, before the record itself.

Step 2: Check what is waiting#

  1. Tap the To send tab. The number at the top shows how many records are waiting, and the line below says "Records saved on the phone, waiting for signal." or the time of the last send.
  2. Each record shows what it is, such as a reading, a visit or an order, the time it was saved and its status.

Step 3: Send when you are back online#

  1. On To send, tap Send now. The button reads Sending… while the app works through the list.
  2. To send each record as soon as it is saved, open the Account tab, tap Sync and turn on Send automatically.
  3. If a record shows Error, read the message under it, fix the cause and tap Try again.

What happens next#

Each record moves from To send to Sending and then to Sent. A reading the service wants checked shows Under review. When the list is done, the app says "Sending complete." or "Some records were not sent."

Records stay on the phone if the app closes or the phone restarts, and a send that was cut off goes back to waiting. Sent records stay listed until you tap Clear sent records under Account → Sync.

Sending twice never records the same work twice. Each record carries its own key, so a repeat is matched to the first copy. If a disconnection or reconnection was already received, the repeat counts as sent.

If you switch organisation with records still waiting, the app warns you and offers Send now or Switch anyway. Records you leave behind wait until you come back to that organisation.

Common problems#

  • "No connection to the server. Try again when you have network." The phone had no usable signal. Wait for signal and tap Send now again.
  • "Not authorized to send this record" followed by an error code. Your role does not allow this kind of record. Ask your supervisor to check your role.
  • "The service rejected this record" followed by an error code. Something in the record no longer fits, for example the round is not in progress yet or the meter is no longer active. Ask your supervisor, then tap Try again.
  • "The photo was not accepted and stayed on this phone." The record was sent without its photo. Show the photo to your supervisor if it is needed.
  • Erase data on this phone under Security also deletes records that have not been sent. Send everything first.

Start today. Set up your utility in minutes.