Manage platform collectors
Register the collectors that bring smart meter readings in for a water utility, give them meters to serve, and suspend or revoke them when needed.
A collector is a small program, installed on a computer or device near the meters, that reads smart meters for one water utility and sends the readings in. It can also run commands on those meters. The platform team registers collectors and follows them on the platform Collectors screen. Once a collector is working, its readings reach the utility with no visit to the meter.
Before you start#
- The utility must already be registered on the platform.
- Someone must be ready to install the collector program on the device, close to the time you register it. The registration token you create only works for a limited time and only once.
- Know which of the utility's meters the collector will serve. A collector belongs to a single utility and only reaches the meters assigned to it.
Step 1: Register the collector#
- In the platform menu, open Collectors and click New collector.
- Click Choose utility and pick the utility.
- Fill in Name and, if useful, Description (optional), such as where the device sits.
- Choose how long the token stays usable under Valid for.
- Click Create collector. The Registration token appears. It is shown only now, so copy it and pass it to whoever installs the program.
Step 2: Connect it and give it meters#
- The installer registers the program with the token. The collector then shows on the list as Online.
- Open the collector and go to the Meters tab.
- Click Assign meter and choose a meter. Repeat for each meter it should serve.
- Check the Instances tab to see each copy of the program that has registered, and Sessions for its open connections.
Step 3: Keep it healthy#
- On the list, Connection shows Online for recent contact and No recent contact when it has gone quiet. Last contact shows when it was last heard from.
- If the token expired before the program registered, open the collector and click Issue token for a New registration token.
- To pause a collector, click Suspend. It stops sending readings and running commands until you click Reactivate.
- If the device is lost or replaced, click Revoke. This is permanent. On the Credentials tab you can also revoke a single credential, which ends the sessions opened with it.
What happens next#
Readings from the collector arrive in the utility's dashboard like any other readings and go through the same checks. Readings that look wrong are flagged for the utility to review. The platform Home counts collectors online and collectors needing attention, so a quiet collector stands out.
Common problems#
- The collector stays on No recent contact. The device is off, has no network, or the program is not running. Ask whoever installed it to check.
- The collector was created, but the token was not. Open the collector and click Issue token.
- A meter sends nothing. It may not be assigned. Check the Meters tab.
- Choose the utility. You must pick a utility before creating the collector.